In preparing for installation of a wireless Airport Extreme 11 b/g/n base sation, i added an Airport Extreme card to my dual 2 GFHz PPC G5. This was the first install of an Airport card in the G5. After making sure the card was fully seated, I tried to identithe card. About This Mac reported it had "no information". I then reseated the card and the antenna plug and then tried to "see" the card. Still "no joy". I also tied to access the card via Airport utilities in Utilities. Again no show!
I do have a an older (flying suacer) wired Airport base station installed and the G5 is attached to a router via Ethernet 10 base T. I accessed the Airport setup Assistant but got the following "No Airport Card Found - If you continue you will only be able to connect via a base sation connected via ethernet".
Bottom line, card not found. My questions are:
1) Will the card be seen only with a new Extreme Base Station and there really is no problem. Perhaps the old base station just could not locate the new card?
2) Does failure to "see" the card indicate there is a problem with the G5 or the card?
Thanks for any thoughts, ideas, or suggestions,
MamaMoose