Author Topic: PCI graphic card for my built-in pm 5500 monitor. (Read 1592 times)

xbomber2002 · « **on:** October 27, 2003, 02:06:54 PM »

the soldered on motherboard ATI rage II graphic card of my powermac 5500 is defective. i have an ATI Xclaim PCI graphic card. i would like to know if is there a mean to make it working with the built in monitor of my machine (PM 5500 is an all in one model like imac). Naturally , the monitor doesn't have a VGA or any other video connector and i'm searching a way to bypass that limitation. Someone did the expérience ?

giantmike · « **Reply #1 on:** October 27, 2003, 03:24:08 PM »

I'm sure you could do this if you got out a soldering gun, and soldered the exact right pins on the VGA port to the exact places on the built in monitor. However, doing such a feat would be dangerous and nearly impossible.

You might be able to pick up a seperate monitor, and run that off the PCI card, but I fear you're out of luck with the internal monitor.

xbomber2002 · « **Reply #2 on:** October 28, 2003, 02:57:40 PM »

the difficulty arises when i try to identify the right connectors or wires in the monitor part of the machine. I really don't know where to connect the 15 vga output pins from the graphic card. I need the electronic scheme of the pm 5500/5400, it's undocumented...Have you got an idea from where can i get it ?

giantmike · « **Reply #3 on:** October 29, 2003, 08:10:46 AM »

Are you really going to try that?!? I highly reccomend ASAINST it! Especially since you would be orking wit ha CRT. Very DANGEROUS!

xbomber2002 · « **Reply #4 on:** October 29, 2003, 04:46:44 PM »

you're quite right. i should before take advices from a good electronics specialist before doing that. could be fatal

News:

Author Topic: PCI graphic card for my built-in pm 5500 monitor. (Read 1592 times)