Author Topic: Disk Utility (Read 1712 times)

sokukodo · « **on:** July 21, 2003, 06:46:57 PM »

I've noticed that when I run Disk Utility from the boot disk and choose "verify disk", it tells me that the volume needs to be repaired; after repairing, I choose "verify disk" again, and I get the same message that it needs to be repaired, so I repair once again, verify, same message ... I've repeated this procedure 5 times and I still get the same message. Should I keep repairing until I get a message that "volume 10.2.6 appears to be ok"?

CyberPet · « **Reply #1 on:** July 21, 2003, 07:15:57 PM »

What is the message you get? I.e. what is it that Disk Utility want to repair?

sokukodo · « **Reply #2 on:** July 21, 2003, 07:18:53 PM »

It just says "volume 10.2.6 needs to be repaired"

FLASH1296 · « **Reply #3 on:** July 21, 2003, 07:48:57 PM »

Stoip. Twice is sufficient. Boot your mac in Verbose Mode. Hold down Command - V while booting ino the comnmand-line. type sudo/sbin fsck -y This will run a more complete File System Check (fsck) Run twice if need be. IF this fails run Disk Warrior 3.0 from the boot CD - or, as an alternative, Norton Disk Doctor 8.0 off of the new Norton SystemWorks 3.0 boot CD.

kelly · « **Reply #4 on:** July 21, 2003, 09:48:05 PM »

I usually run Disk Utility from a Partition.

I never bother to verify. I just Repair.

What brought this up? Anything go wrong?

sokukodo · « **Reply #5 on:** July 21, 2003, 10:35:44 PM »

Actually, things were getting sluggish, and when that happens I usually prebind and/or do the disk utilty thing ...

News:

Author Topic: Disk Utility (Read 1712 times)