Author Topic: Carbon Copy Cloner problem (Read 3570 times)

Thomas S. England · « **on:** December 18, 2003, 08:40:51 AM »

Before downloading the latest OS version, I thought it would be prudent to back up my existing 10.3.1 to an external drive.

So I did, using CCC & having those preferences set to "Make Bootable". This has always worked fine in the past.

Now, although that backed up 10.3.1 shows up as a bootable system, when I select it as my startup, I get the Apple symbol, but it goes no further.

I've repaired permissions, repaired the disk, but nothing helps.

pendragon · « **Reply #1 on:** December 18, 2003, 09:14:02 AM »

Thomas, Alas I have no true answer to the issue. But, when you made your clone, were you using CCC v2.3?

Harv

Thomas S. England · « **Reply #2 on:** December 18, 2003, 10:03:02 AM »

I was using 2.2, following your question, I downloaded 2.3, but got the same results.

There were a couple of errors during the process, the most serious of which seemed to be:

I've always had a couple of these errors when using CCC, usually about some
Appleworks files, which I've ignored without consequence.

Bruce_F · « **Reply #3 on:** December 18, 2003, 10:18:55 AM »

Thomas, have you run Disk Utilities > Repair Permissions?

Just wondering... Maybe CCC runs into problems if the permissions are messed up.

Thomas S. England · « **Reply #4 on:** December 18, 2003, 11:19:56 AM »

Yes, ran permissions & then CCC also repaired permissions before the clone.

pendragon · « **Reply #5 on:** December 18, 2003, 11:59:12 AM »

Thomas, If you have not already, a scan of the CCC Forum may help. http://forums.bombich.com/ Or, perhaps a post. The forum are all monitored by Mike Bombich, so the guidance there should be the gospel...

Harv

News:

Author Topic: Carbon Copy Cloner problem (Read 3570 times)